ACU-RITE 00502, Instruction Manual

Page: 12 / 22

12
5-in-1 Sensor Installation Guidelines
INSTALLATION HEIGHT
Mount the sensor at a minimum height of 5 feet (1.5 meters)
off the ground, in an open area. Higher is better for wind measurements - the
National Weather Service recommends 33 feet high!
MOUNTING OPTIONS
The included mounting bracket is designed to screw
directly onto wooden posts or surfaces that are 2”x4” or larger. The sensor
can also be mounted directly to 3/4” steel or PVC pipe (available at hardware
stores and home centers).
LEVEL INSTALLATION
Use the bubble level
(included on top of sensor) to ensure level
installation for accurate wind measurement.
NO OBSTRUCTIONS
ABOVE OR AROUND
SOLAR CELL INSTALLATION
Install the
sensor with the
solar cell facing SOUTH.
This ensures the cell receives as much sun as
possible and orients wind direction.
5-in-1 Sensor Installation
1. Fasten mounting base (included) to a post
or pipe (not included) using the 4 longer
screws included in the hardware bag.
(1.5 meters)
2. Insert the mounting base into the hole on
the bottom of the sensor.
3. Make sure the arrows on the top of the
sensor are pointed in the proper direction
and the bubble level is centered. The
solar cell should be facing south to
properly orient the wind direction.
SOUTH
4. Fasten the sensor into the mounting base using the 2 shorter screws included
in the hardware bag.
The 5-in-1 sensor is now
ready to use.
Clear Data Collected During Installation
When installation is complete, clear erroneous data from the display unit by
pressing the “CLEAR TODAY” button, on the back of the display until inside the
battery compartment. This button will clear data recorded since 12:00 am.
Basic Setup is Complete
The 5-in-1 sensor will now synchronize with the display unit. It may take a few
minutes for synchronization to complete. If both or one of the units appear to
be functioning improperly, please refer to the troubleshooting section.