Operation Manual
CL01-2 Wall Controller
Operation Manual - CL01-2 Wall Controller
Document: 0525-081
Ver. 1 190903
14
7. Press the
PROG
button to enter the set time/day and then press
EXIT
button to exit the set up procedure.
8. Press the
DISPLAY
button to make sure that you set the time and day correctly.
NOTES
• Current Fan Speed and Mode of Operation will also be displayed in the screen.
• During a Power Failure, the clock will retain the time and day via the backup battery inside the system.
09.08. Setting the Upper and Lower Temperature Limits
NOTES
1. Default Upper and Lower Limits:
• Upper: 30
o
C
• Lower: 16
o
C
2. The air conditioning system must be turned Off before performing these procedures.
This feature allows you to set the upper and lower temperature limits on your Control Interface .This can be used in a
variety of ways:
• You may want the maximum set-temp limited to 25
o
C and the minimum set- temp to 20
o
C, thus stopping
anyone from setting the temperature too high or too low.
• You may want to lock the set-temp to 22
o
C to stop anyone else adjusting the set-temp up and down. To do this,
simply adjust the upper and lower limit until they are the same.
09.08.01. Setting Lower Limit
1. Press the
button and then the
button. You must press the two buttons in quick succession.
The display will now show the lower limit for 3 seconds and this is confirmed by flashing
LOW
indicator.
2. While the lower limit is displayed, use the
or
buttons to adjust the lower limit up or down.
After 5 seconds the lower limit will be automatically accepted. You cannot adjust the lower limit above
your current set-temperature.
09.08.02. Setting Upper Limit
1. Press the
button and then the
button. You must press the two buttons in quick
succession. The display will now show the lower limit for 3 seconds and this is confirmed by flashing
HIGH
indicator.
2. While the upper limit is displayed, use the
or
buttons to adjust the lower limit up or down.
After 5 seconds the lower limit will be automatically accepted. You cannot adjust the upper limit below
your current set-temperature.
