HOW TO USE THE
COUNTDOWN TIMER
1. Repeat Pressing the MODE
button to display
T
T
T
TR
R
R
R
(COUNTDOWN TIMER)
operating mode.
2. Press & Hold the LAP/RESET
Button until the Seconds digits
BLINK. Press the
START/STOP button to set to
the seconds wanted. You can
select from
0
to
59
seconds. If
you do not wish to set the
seconds, go to #3 below.
3. Press the MODE Button to go to
the hours. The hour digits will
BLINK. Press the
START/STOP button to set the
number of hours wanted. You
can select from
0
0
0
0
to
23
23
23
23
hours.
4. Press the MODE Button to go to
the minutes. The minute digits
will BLINK. Press the
START/STOP button to set the
number of minutes wanted. You
can select from
0
0
0
0
to
59
59
59
59
minutes.
5. Press LAP/RESET button when
you have finished. The display
will stop blinking.
To reset the Countdown Timer
for a different time see "How to
Use the Countdown Timer" and
follow instructions.
TO START THE
COUNTDOWN TIMER,
Press the START/STOP button
(after the countdown timer is set).
The timer will start to countdown.
To interrupt, press the
START/STOP button. Pressing the
START/STOP button again will
start the countdown from where it
last left off.
Note: When Countdown Timer is
set for more than ten minutes, a
short single reminder will advise
you of 10 minutes remaining and
then at 5 minutes remaining.
AUTO RELOAD
COUNTDOWN TIMER
will
automatically reload for the time
preset, when the timer reaches “
0
0
0
0
”
If you do not wish to start the
countdown again immediately,
press the START/ STOP button
twice, if alarm is activated. Press
once to stop the countdown if
alarm is not activated.
To restart the preset countdown at
any time, press the START/STOP
button while in the
COUNTDOWN -
TR
TR
TR
TR
mode.
TO USE THE REPEATABLE
COUNTDOWN TIMER WITH
PAUSES IN BETWEEN
When the auto-repeat countdown
timer reaches zero it automatically
alarms and starts to countdown
again for the preset time. You can
cancel the countdown before it
reaches zero and return to the
original countdown time as needed.
You must be in the Countdown
Timer Mode to reset to the original
countdown time.
PUSH the LAP/RESET button and
HOLD IT for approximately 2 to 3
seconds. Digits will flash showing
the amount of time that the
countdown was set for originally.
Push the LAP/RESET button once,
and the digits will stop flashing. (If
you do not push the LAP/RESET
button to stop the flashing, the
digits will stop flashing
automatically after 2 minutes.)
To activate the start of the
countdown when you need it, push
the START/STOP button once.
HOW TO USE THE
STOPWATCH
1. Repeat Pressing the MODE
button to show
STOPWATCH
on the display.
2. To start the Stopwatch press the
START/STOP button. The
Stopwatch will start keeping
time and the Icon (symbol at the
top of the display) will flicker to
show the action.
TO STOP THE STOPWATCH,
press the START/STOP button.
Pressing the START/STOP button
again will start the stopwatch
running from where it last left off.
The Stopwatch can count up to
23
23
23
23
hours,
59
59
59
59
minutes and
59
59
59
59
.
99
99
99
99
seconds. Each hour accumulated
shows at the top left of the display.
To RESET the stopwatch to zeros,
press the LAP/RESET button,
when it is in a stop position.
Split Timing on Stopwatch
1. Start the Stopwatch by pressing
the START/STOP button. The
stopwatch will start keeping
time.
2. Press the LAP/RESET button.
The watch will continue
counting the time even though
you do not see it on the display.
The Icon at the top of the
display will continue to flicker
to show action and that counting
continues.
3. Press the LAP/RESET button
again and the display will
change and show the time that
has accumulated in total.
To RESET the Stopwatch, press
the START/STOP button and then
press the LAP/RESET button.
HOW TO SET THE SECOND
CLOCK
1. Repeat Pressing the MODE
button to show
SECOND
CLOCK
(T2)
(T2)
(T2)
(T2)
2. Press & Hold the LAP/RESET
button until the Hours digits
BLINK.
Press the START/STOP button
to rotate to the hour you wish to
set. (In
12
Hr Mode, use
PM
indicator for correct setting of
afternoon or evening.)
3. Press the LAP/RESET button
when desired hour has been set.
NOTE: Only the hour can be set in
second clock mode. (The minutes
and seconds will be the same as the
Calendar Clock)
HOW TO USE THE EL BACK
LIGHT
Press the LIGHT button to light up
the LCD display at any time. The
screen will be lit for approximately
3 seconds before going off
automatically.
The EL back light will flash when
an alarm is activated
BATTERY INFORMATION
Your watch uses a Standard 3 volt
lithium CR2032 or equivalent
battery. Battery life will vary due
to how often the EL back light and
vibration function are used. To
maintain water resistance, a
qualified person should replace the
battery
ONE YEAR LIMITED
WARRANTY
Your VibraLITE 3
is warranted to
be free from defects in material or
workmanship for One Year from
the date of purchase. This is a
limited warranty and covers watch
functions only. This warranty does
not apply to the battery, band or to
any unit which has been subject to
misuse, negligence or accident.
This warranty is void if the watch
has been tampered with, altered, or
repaired other than by a qualified
service center. VibraLITE watches
are not intended to be worn during
swimming, diving, or showering.
At its option,
GLOBAL ASSISTIVE
DEVICES, INC
. may select to
replace the unit, rather than repair
it. During the warranty period,
return the watch, with dated proof
of purchase, in a secure package,
insured and with shipping charges
prepaid. No C.O.D. packages will
be accepted. Please include a note
describing the service required and
include $10.00 (check, money
order, Visa, MasterCard, American
Express, or Discover) for shipping
and handling in the USA. Other
Countries please contact us for
pricing.
OUT OF WARRANTY SERVICE
Follow the same procedure for
shipping to us as you would for
warranty service. Be sure to
include a description of the
problem. An estimate will be
submitted for your approval for
any labor or parts not covered by
the warranty before any work is
performed.
SERVICE:
Before sending your unit for
service, have the battery checked
and/or try resetting by pushing all
four buttons at the same time and
hold until the display clears.
Qualified service personnel should
service this unit. The user should
not attempt to service the unit.
Servicing should be referred to:
GLOBAL ASSISTIVE DEVICES, INC.
4950 North Dixie Highway,
Fort Lauderdale FL 33334
DISCLAIMER:
In no event shall Global Assistive
Devices, Inc. be held liable for any
special, incidental, indirect or
consequential damages whatsoever
including, but not limited to,
damages for loss of property,
personal injury, loss of privacy,
failure to meet any duty,
negligence, and any other loss
whatsoever, however caused, even
if Global has been advised of the
possibility of such damages. This
disclaimer of liability applies to
any damages or injury, including
but not limited to those caused by
any failure of performance of the
product. Responsibility for
selection, safety and suitability of
any product rests with the
consumer. Circumstances or
consequences arising out of or in
any way related to the use of or
inability to use our products is the
responsibility of the consumer.
Global Assistive Devices, Inc.
cannot be held liable in any way.
