1
Verify Contents
Verify that the package contents are correct by checking the items against the packing list.
Note:
Please contact your dealer for damaged or missing items.
NVR Pre-Installation
NVR Installation
During the installation of the NVR:
1.
Use brackets for rack mounting.
2.
Ensure there is ample room for audio and video cables.
3.
When installing cables, ensure that the bend radius of the cables are no less than five times than its diameter.
4.
Connect both the alarm and RS-485 cable.
5.
Allow at least 2cm (~0.75-inch) of space between racks mounted devices.
6.
Ensure the NVR is grounded.
7.
Environmental temperature should be within the range of -10
º
C ~ 55
º
C, 14º
F ~ 131º
F.
8.
Environmental humidity should be within the range of 10% ~ 90%.
Hard Disk Installation
1.
Remove the cover from the NVR by unfastening the screws on the rear and side
panel.
2.
Connect one end of the data cable to the motherboard of NVR and the other end to the HDD.
Quick Operation Guide
for the SX-1400
Series NVR
Thank you for purchasing our product. If there is any question or request, please do not hesitate to contact dealer.
This manual is applicable to
the SX-1400 series NVR.
The
SX-1400
series NVR are highly advanced surveillance equipment that should be installed with care. Please
take into consideration the following precautionary steps before installation of the NVR.
1.
Keep all liquids away from the NVR.
2.
Install the NVR in a well-ventilated and dust-free area.
3.
Ensure environmental conditions meet factory specifications.
4.
Install a manufacturer recommended HDD.
Before you start:
Before installing a hard disk drive (HDD), please make sure the power is disconnected from the NVR. A factory
recommended HDD should be used for this installation.
Tools Required:
Screwdriver.
