Activa 12241 Dakota, Instructions For Assembly And Use

Page: 18 / 23

Art. Nr.: 12241 Dakota
Seite 18 von 23
D
13. Installation
Do not put your barbecue trolley into operation until you have checked that all gas con-
nections are tight. When starting up, keep a safe distance from the burner, as a pilot
flame could occur during start-up. A safe ignition process is guaranteed if you proceed as
follows:
1. Check gas tightness of all lines and valves.
2. Open the cylinder valve.
3. Open all hoods and lids to prevent gas mixture from forming.
➔
Danger of explosion !
➔
Warning!
To start the appliance for the first time or after changing the gas cylinder,
press and hold the regulator button for 2 minutes to vent the lines.
4. Turn all the control knobs clockwise (to the right) to the OFF/AUS position.
5. Press the control knob with the piezo symbol and turn it anticlockwise to the
large flame MAX position. During this process, the mechanical piezo ignition switches
on. You will hear a sound from the control knob. If this sounds, the burner should be
lit. If not, try several times. Once the burner is lit, press and hold the button for about
5 seconds.
6. If, in exceptional cases, ignition does not occur after the piezo igniter has been
pressed 3 - 4 times, repeat the procedure after waiting for approx. 2 minutes:
7. Light additional burners. The first burner ignites the nearby burner by skipping the
flame.
8. Always turn the regulation knob slowly to the larger flame MAX position. If you turn it
quickly, the flame may go out.
9. To switch off the burner, press and turn all the control knobs to the OFF position and
close the valve on the gas cylinder.
The appearance of the flame:
•
The flame of the burner(s) must be blue and uniform. There must be no yellow
sparks, loud noises or gaps between the bottom of the flame and the nozzle.
•
A yellow flame indicates insufficient oxygen supply. Loud noises or gaps
between the flame and the nozzle are signs of excessive oxygen supply.
•
Check the appearance of the flame every time you use it. If the flame looks abnormal,
contact a specialist to have the appliance reset.