4
of
9
This device is intended only for OEM integrators under the
following conditions:
1) The antenna must be installed such that 20 cm is maintained between the antenna and users,
and
2) This device and its antenna(s) must not be co
‐
located with any other transmitters except
inaccordance with FCC multi
‐
transmitter product procedures. Referring to the multi
‐
transmitterpolicy,
multiple
‐
transmitter(s) and module(s) can be operated simultaneously without C2P.
3) For all products market in US, OEM has to limit the operation channels in CH1 to CH11 for 2.4G band
& CH36 to CH165 for 5G band by supplied firmware programming tool. OEM shall not supply any tool or
info to theend
‐
user regarding to Regulatory Domain change.
USERS MANUAL OF THE END PRODUCT:
In the users manual of the end product, the end user has to be informed to keep at least 20cm
separation with the antenna while this end product is installed and operated. The end user has to be
informed that the FCC radio
‐
frequency exposure guidelines for an uncontrolled environment can be
satisfied. The end user has to also be informed that any changes or modifications not expressly
approved by the manufacturer could void the user's authority to operate this equipment.
If the size of the end product is smaller than 8x10cm, then additional FCC part 15.19 statement
isrequired to be available in the users manual: This device complies with Part 15 of FCC rules.
Operation is subject to the following two conditions: (1) this device may not cause harmfulinterference
and (2) this device must accept any interference received, includinginterference that may cause
undesired operation.
LABEL OF THE END PRODUCT:
The final end product must be labeled in a visible area with the following " Contains
FCCID:LNQ802R8822". If the size of the end product is larger than 8x10cm, then the following FCC part
15.19 statement has to also be available on the label: This device complies with Part 15of FCC rules.
Operation is subject to the following two conditions: (1) this device may not causeharmful interference
and (2) this device must accept any interference received, includinginterference that may cause
undesired operation.