Issued/Revised: 08/29/13
UP163F RECUMBENT CYCLE (FOOTING)
FitTech
800.458.5872
www.actionfitoutdoors.com
3
ActionFit
UP163I RECUMBENT CYCLE (IN GROUND)
UP163S RECUMBENT CYCLE (SURFACE)
NOTE:
Do not overtighten bolts. To overtighten may cause buckling or dimpling of some parts.
NOTE:
Read installation instructions thoroughly before starting assembly. Pour concrete only after final assembly is completed.
Bracing material is required during assembly.
NOTE:
Assembly and leveling times will be greatly reduced if a transit is used to set location and depth of ground holes.
INSTALLATION INSTRUCTIONS FOR UP163F (FOOTING):
1. Dig holes or drill holes according to Plan View and Elevation View.
NOTE:
Due to extremes in weather and soil conditions, hole
size may have to be increased to meet local conditions.
2. Fill hole with concrete. While the concrete is still soft, yet firm enough to support the Recumbent Cycle, Place (4) Anchor Bolts of
the Recumbent Cycle in postion. See Footing Detail.
NOTE:
Use Recumbent Cycle as a template for Anchor Bolt location, then
remove Recumbent Cycle.
IMPORTANT:
DO NOT MOUNT THE RECUMBENT CYCLE TO THE ANCHOR BOLTS FOR AT LEAST 7 DAYS.
3. After concrete has cured and set for a minimum of 7 Days, attach Recumbent Cycle to 3/4" Anchor Bolt using 3/4" Flat Washer
(2" O.D.), 3/4" Lock Washer, and 3/4" Hex Nut. See Footing Assembly Detail.
4. Attach Base Cover to Equipment Post using Base Cover Nut and Base Cover Bolt included with Base Cover. See Base Cover
Detail.
INSTALLATION INSTRUCTIONS FOR UP163I (IN GROUND):
1. Dig holes or drill holes according to Plan View and Elevation View.
NOTE:
Due to extremes in weather and soil conditions, hole
size may have to be increased to meet local conditions.
2. Attach the Footbuck Weld Assembly to the Recumbent Cycle using 3/4" Hex Nut, 3/4" Lockwasher, 3/4" Flatwasher (2" O.D.),
3/4" x 2" Hex Head Cap Screw. See In-Ground Assembly Detail.
3. Place Recumbent Cycle into hole making sure it rests on the brick. See In-Ground Detail.
4. Level Recumbent Cycle using sway bracing.
5. Pour concrete according to the Plan View and Elevation View. Allow concrete to cure for a minimum of 7 days.
6. Attach Base Cover to Equipment Post using Base Cover Detail.
INSTALLATION INSTRUCTIONS FOR UP163S (SURFACE):
1. Mark correct location of holes for Wedge Anchor using the Base Plate as a guide.
2. Drill 3/4" x 2 1/2" hole in concrete for Wedge Anchor. See Surface Detail.
3. Insert Wedge Anchors and secure with 3/4" Flatwasher (2" O.D.), 3/4" Lockwasher, and 3/4" Hex Nut. See Surface Assembly
Detail.
4. Attach Base Cover to Equipment Post using Base Cover Detail.
