Revised
September 27, 2016
Page | 9
Repairs and Maintenance
All bearings are sealed and need no additional greasing.
Track can be adjusted by loosening both bolts on the front idler wheels, inside and outside.
Track tensioners can be tightened with a 9/16” wrench by holding the lock nut and turning
track tensioner bolts clockwise an even amount. Adjustment is only needed if the track
tension does not meet the below spec. IT IS NOT NECESSARY TO OVER TIGHTEN THE
TRACKS. Re-tighten front idler wheels, inside and outside to 14Nm.
Cleaning your Trackchair
The Action Trackchair can be washed with a garden hose, do not use high pressure wash to
clean the chair. Always cover the joystick with a plastic bag to protect it from getting
moisture inside.
THE
JOYSTICK IS NOT WATERPROOF
and should be covered when washing,
or stored outside or when transporting behind the vehicle open.
Do not spray water directly onto the motor controller under the seat.
Press down on track with 9 to 11kg of force and
observe location of track lug. When properly
tensioned the lug at blue arrow should just contact
“A" frame with 9 to 11kg of force. Note arrow
Rotate the track so an
internal lug is directly
above the “A” frame
cross support as shown
Use suitable spring tension gauge
purchased from your distributor/dealer
