actiLib Library 4U
– User and Service Guide
Page 87 of 103
IMPORTANT
Before pulling the lower drive sled please pull forward
the product ID slide located below the drive sled (see
detail 1). Otherwise the slide or the attached
label could be damaged.
2.
Pull straight back on the tape drive handle to remove it from the Library. Take care to
slightly push down the product ID slide so it does not interfere with the drive sled (see
).
Figure 60 Tape drive removal
To replace a tape drive:
1.
Before installing the new drive inspect the connectors on the tape drive. Ensure that the
connectors are intact, free of any foreign objects, and have no cracks or deformed or bent
contacts.
2.
Slowly insert the new tape drive into the drive bay, and align the connectors on the Library
while supporting the drive assembly (see
Figure 61 Installing a tape drive
3.
Push the tape drive slowly into the drive bay until the drive seats itself against the back of
the Library.
Summary of Contents for actiLib Autoloader 4U
Page 40: ...actiLib Library 4U User and Service Guide Page 40 of 103 Figure 24 Interaction Mode Commands ...
Page 43: ...actiLib Library 4U User and Service Guide Page 43 of 103 Figure 27 Interaction Mode Service ...
Page 60: ...actiLib Library 4U User and Service Guide Page 60 of 103 Figure 40 Configuration license key ...
