User Manual
ComXS-320
IR14618B User Manual ComXS-320 11.05.2017
Page 10/12
Reorient or relocate the receiving antenna.
Increase the separation between the equipment and receiver.
Connect the equipment into an outlet on a circuit different from that to which the
receiver is connected.
Consult the dealer or an experienced radio/TV technician for help.
5.2.1.
FCC
END PRODUCT LABELING INSTRUCTION
In accordance with 47 CFR § 15.19 the end product shall bear the following statement in a
conspicuous location on the device:
“This device complies with Part 15 of the FCC Rules. Operation is subject to the following
two conditions: 1. This device may not cause harmful interference, and 2. This device
must accept any interference received, including interference that may cause undesired
operation.”
When the device is so small or for such use that it is not practicable to place the statement
above on it, the information shall be placed in a prominent location in the instruction
manual or pamphlet supplied to the user or, alternatively, shall be placed on the container
in which the device is marketed. However, the FCC ID label must be displayed on the
device.
In case where the final product will be installed in locations where the end-consumer
is
not able to see the FCC-ID and/or this statement, the FCC-ID and the statement shall be
also included in the end-product manual.
For an end product using the ComXS-320 there must be a label
containing, at least, the following information.
This device contains
FCC ID: XB7-COMXS320
5.3
IC
This device complies with Industry Canada licence-exempt RSS
standard(s). Operation is subject to the following two conditions:
1. This device may not cause interference, and
2. this device must
accept any interference, including interference that may cause
