www.acti.com
Hardware Manual
10
Installation Procedures
This section describes procedures in mounting the camera on a flat surface.
NOTE:
The camera images on this documentation are for reference only and may be different
from the actual camera.
Step 1: Prepare for Installation
1.
Before installing the camera, prepare the additional accessories required for installation.
2.
Determine whether the cable will go through a hole on the surface or be routed along the
surface. Note also the direction to which the cable will be routed to attach the bundled drill
template on the surface according to the direction of the cable.
3.
Drill the screw holes. Depending on the material of the surface where the camera will be
installed, it may be necessary to drill the two (2) screw holes and use the supplied screw tox.
4.
Loosen the two (2) screws using the bundled wrench then lift the dome cover.
NOTE:
The dome cover is attached to the camera body by a string; do not abruptly lift the
dome cover!
