4 Quick Installation Guide
An optional hard disk drive or HDD (sold separately), can be installed inside the
LPR to store license plate recognition results.
MAKE SURE THE UNIT IS NOT CONNECTED TO POWER before installing the
hard disk.
INSTALL THE HARD DISK
3
Step 1
Remove the two (2)
screws; then slide the
top cover backwards to
pull off the cover.
Step 2
Remove the screw
securing the HDD plate;
then lift to remove the
plate.
Step 7
Connect the other end
of the SATA cable to the
mainboard.
Step 8
Connect the power
connector of the HDD to
the mainboard.
Step 9
Secure the plate with
one (1) screw. Close the
LPR with the top cover.
Step 4
Attach the side screw to
fix the HDD position on
the plate.
Step 6
Connect the bundled
SATA cable to the SATA
connector on the HDD.
Step 3
Orient the HDD on
the plate with its SATA
connector facing towards
the black foam.
Step 5
On the underside of the
plate, attach 2 to 4 screws to
secure the HDD.
NOTE:
Applicable screw holes vary
depending on the HDD models. At least
2 screws are required to secure the HDD.
