4
Standalone NVR Quick Installation Guide
RACKMOUNT THE UNIT
This unit is designed to be mounted on a standard server rack, which
occupies 2U (3.5″) of vertical space.
INR Sliding Rail Kit
HARD DISK INSTALLATION
REMOVE THE TRAY
Step 1
Slide the lock tab aside,
and the hinge tab will pop out by
itself.
Step 2
Hold the tab lever and
pull out the tray.
INSTALL THE TRAY
Step 4
Place your thumb on the lock to
push the tray into position in the
chassis.
Step 5
Press the hinge tab
until it clicks into place.
MOUNT THE DISK
Step 3
Loosen the two screws on the tray to remove the dummy disk. Secure the
hard disk on the tray with the provided disk screws. Make sure the disk
connector faces towards the SATA contacts inside the unit.
Make sure this unit is turned off, and insert the hard disks into the disk bays
following the sequence of tray numbers.
1.
Allow a minimum of 5 cm clearance at the
front and the rear for front-to-back airflow of
the unit.
2. Use the bundled rail kit, and install that to
support the entire unit.
3.
Secure the unit onto the rack.