4
Standalone NVR Quick Installation Guide
HARD DISK INSTALLATION
TURN OFF THIS UNIT
before you move the trays. Repeat the following steps to
install the disks into Storage Disk bays.
REMOVE THE TRAY
Step 1
Slide the lock tab up,
the hinge tab will pop
out by itself.
Step 2
Pull the hinge tab to 90
degress from the front,
and pull out the tray.
INSTALL THE TRAY
Step 4
Place your thumb on the lock to push
the tray into position in the chassis.
Step 5
Press the hinge tab until it clicks into
place.
MOUNT THE DISK
Step 3
Mount the disk by locking it
with supplied disk screws to
the bottom of the tray.
CONNECT THE DEVICES
The examle below displays a network consisting of only GNR, network cameras and
required peripherals. Please remember to enable the DHCP service on your router
for GNR to obtain an IP address automatically.
Power Source
Switch
Cameras
eSATA
Storage
USB Devices
Monitor
Note
To assign a static IP address to GNR, enter
Windows and configure the network
settings in
Network and Sharing Center
.
