Precaution
The optical mouse
can not
work on a glass or mirror surface. Avoid operating this mouse on a
glossy surface; otherwise, this mouse may not operate normally.
For consideration of saving battery power, it is strongly recommended to operate an optical mouse
on a bright surface with fine texture to obtain lower power consumption of the high illumination
LED. A very dark surface will cause higher power consumption.
For optimal performance, place the receiver at least 8 inches or 20 centimeters away from other
electrical devices, such as the computer, the computer monitor, speakers or other external storage
drives.
For a better transmission distance, avoid using this device on a metal plate or desktop because a
large surface of iron, aluminum, copper and other metal will act as a shield or ground to the RF
antenna of the mouse and receiver. Operating on a metal surface may shorten the transmission
distance.
If your notebook computer has a metal (contains Al or Mg) case, the metal housing of the LCD
panel will isolate partial radiation of the RF signal from the mouse.
This could possibly result in reducing the distance of transmission when you operate the mouse
right in front of the notebook and when the receiver is connected on the back of the notebook.
However, the RF mouse should work properly while you are
operating the mouse just beside your desktop computer.
Hardware Installation Guide (Mouse)
Insert the battery
1. Open the battery cover
2. Insert 2 AAA rechargeable batteries in correct direction
3. Close the battery cover.
Note. It's a rechargeable product. Please
using rechargeable battery only,
or will damage this
product, even your computer.
Connect the receiver with computer.
1. Turn off your computer
2. Disconnect the current mouse
3. Plug the adapter into the receiver
4. Plug the USB connector (receiver) into USB port (computer).
5. Turn the computer on
a. USB is a PnP device; you can plug the device no matter the computer is on or off. Of course,
you can remove USB device in the same way.
b. If the device is HD or pen drive or any device which can store files, stop the device than remove
is the best way to protect.
.
Synchronize the RF Mouse (Pairing)
If the mouse is in sleep mode click the mouse button once to wake it up.
1. Bring the mouse within 1 ft range from the receiver.
2. Switch on the mouse.
3. Hold the mouse upside-down and use a pointed object, such as a pen tip, to click the
“CONNECT” button (ID button) once.
Note. *Poke the Mouse Connect button first, and then click the receiver's button.
The mouse
must
in mouse mode.
7