100 + 80 + 80 + 400 + 400 = 1060mA. In the event of a power fail, Battery 1 will
supply the pcb, readers and 1 lock. Battery 2 will supply the lock for doors 2. The
current draw on battery 1 would be 100+80+80+400 = 660mA A fully charged 7Ahr
battery for battery 1 would last 7/0.66 =
10.6 hours
.
After a mains power failure, the ACTpro200 will continue to operate while the
batteries are charged. After the batteries discharge, the ACTpro200 will disconnect
the batteries to protect them from being ‘deep-discharged’.
On receipt the unit should be carefully unpacked and inspected to ensure that no
transit damage has occurred. Provided that this inspection is satisfactory and reveals
no evidence of damage then installation can proceed.
Mount the ACTpro200 directly to the wall with the supplied screws. The unit must be
mounted in a well-ventilated area that allows for accessibility after installation and
must not be adjacent to combustible materials or in an area that exceeds temperatures
of 45°C. Adequate ventilation should be provided to keep the unit cool and the
ventilation slots around the cabinet should not be covered in any way.
This unit is designed for use from an AC supply of between 195V min and 253V max.
AC rms 50/60Hz. Mains power should be connected to the ACTpro200 by a licensed
electrician in accordance with local and national codes
For continued protection against fire hazard, replace fuses with the same type and
rating.
A PROTECTIVE EARTH must be provided for safety in accordance with EN61010
Part 1 : 1993 : Clause 6.5.1.
An appropriate Mains Isolation switch (Mains on/off) should be fitted between the
AC input of the unit and the equipment electrical supply plug to allow equipment
servicing.
Before any maintenance of the product, ensure mains is disconnected from the
ACTpro.
www.accesscontrol.ie +353 1 466 2570
All manuals and user guides at all-guides.com