Acson international ADB100D, Manual

Page: 18 / 284

16
5. AUTO RANDOM RESTART
When power resumed, the unit will automatically restart and operate at the previous setting as before power
failure occurred. (Remove jumper at JH/JP1 will cancel the auto random restart function. Please refer to
wiring diagram for the location of the JH/JP1).
1. “ON/OFF” switch
•
Press to start the air conditioner unit.
•
Press again to stop the unit.
2. Temperature setting
•
Set the desired room temperature.
•
Press button to increase or decrease the set
temperature. Setting range are between 16
°C
to 30
°C
(60
°
F to 80
°
F).
3. Operation Modes
•
Press the “mode” button for select the type of
operating mode.
- Cooling Only :
COOL, DRY, FAN
- Heat Pump :
AUTO, COOL, DRY, HEAT, FAN
(AUTO mode is represented by bothCOOL and
HEAT LED light on)
4. Fan Speed selection
•
Press the button until the desired fan speed is
achieved.
5. Timer
•
Press the set button to select the switch timer
of the air conditioner unit (the setting range is
between 1 to 10 hours).
6. “Sleep” mode
•
Press button to activate the sleep function can
only be activated under “cool” or heating mode
operation. When it is activated under “cool”
mode operation, the set temperature will
increase 0.5
°C after 30
minutes, 1
°C after 1 hour
and 2°C after 2
hours. If it is actiaved under
“HEAT” mode operation, the set temperature
will be descreased 0.5
°C after 30 minutes, 1°C
after 1 hour and 2
°C after 2 hours.
7. Air Swing
•
Press button to activate the automatic air swing
function.
8. Sensor
•
Infra red sensor to receive signals from wireless
controller.
9. LED Display
•
To display the set temperature (in
°C) and
timer
delay setting (in hours).
10. Transmission source
•
To transmit signals to the air conditioner.
SLM AC-5300 (OPTIONAL)
SLM CONTROLLER OPERATING INSTRUCTIONS