Acson international ACC 10CW, Manual

Page: 26 / 172

24
1. Transmission source
•
The source where the signal will be transmitted.
2. Signal Transmission indication
•
Blink to confirm the last setting has been send to the unit.
3. On/Off Button
•
Press once to start the air conditioner.
•
Press again to stop the unit.
4. Temperature setting
•
To set the desired room temperature, press the button to
increase or decrease the set temperature.
•
The temperature setting range is from 16°C to 30°C
(Optional setting 18°C to 30°C).
•
Press both buttons simultaneously to toggle the tempera-
ture setting between °C and °F.
5. Operation mode
•
Press the MODE button to select the type of operating
mode.
•
For cooling only unit, the available modes are : COOL,
DRY & FAN.
•
For heat pump unit, the available modes are : AUTO,
COOL, DRY, FAN & HEAT.
6. Fan speed selection
•
Press the button until the desired fan speed is achieved.
7. ON timer setting
•
Press the SET button will activate the on timer function.
•
Set the desired on time by pressing the SET button
continuously. If the timer is set to 7.30am, the air condi-
tioner will turn on at 7.30am sharp.
•
Press the CLR button to cancel the on timer setting.
Operation Guide for G8
8. OFF timer setting
•
Press the SET button will activate the off timer function.
•
Set the desired off time by pressing the SET button
continuously.
•
Press the CLR button to cancel the off timer setting.
9. Automatic air swing
•
Press the SWING button to activate the automatic air
swing function.
•
To distribute the air to a specific direction, press the
SWING button and wait until the louver move to the desired
direction and press the button once again.
10. Sleep mode setting
•
Press the button to activate sleep mode. This function is
available under COOL, HEAT & AUTO mode.
•
When it is activated in COOL mode, the set temperature
will be increased 0.5°C after 30mins, 1°C after 1 hour and
2°C after 2 hours.
•
When it is activated in HEAT mode, the set temperature will
be decreased 1°C after 30mins, 2°C after 1 hour and 3°C
after 2 hours.
11. Clock time setting
•
Press or - to increase or decrease the clock time.
12. Turbo function
•
Press button for fast cooling or heating operation.
•
The temperature will be increased internally if it is in the
HEAT mode, decreased if in COOL or DRY mode. Fan
speed will be increased if it is not at maximum speed.
•
The temperature & fan speed will resume to user setting if
the button is pressed again or after 20mins.
•
Available under HEAT, COOL & DRY modes only.