AcSiP EK-ST50, User Manual

Page: 15 / 15

AcSiP Technology Corp
. www.acsip.com.tw
2.8 Label and compliance information
The final end product must be labeled in a visible area with the following: “Contains FCC ID: 2ADWC
-EK-
ST50H”.
The grantee's FCC ID can be used only when all FCC compliance requirements are met.
2.9 Information on test modes and additional testing requirements
This transmitter is tested in a standalone mobile RF exposure condition and any co-located or simultaneous transmission with other transmitter(s)
or portable use will require a separate class II permissive change re-evaluation or new certification.
2.10 Additional testing, Part 15 Subpart B disclaimer
This transmitter module is tested as a subsystem and its certification does not cover the FCC Part 15 Subpart B (unintentional radiator) rule requirement
applicable to the final host. The final host will still need to be reassessed for compliance to this portion of rule requirements if applicable.
As long as all conditions above are met, further transmitter test will not be required. However, the OEM integrator is still responsible for testing
their end-product for any additional compliance requirements required with this module installed.
IMPORTANT NOTE: In the event that these conditions can not be met (for example certain laptop configurations or co-location with another transmitter),
then the FCC authorization is no longer considered valid and the FCC ID can not be used on the final product. In these circumstances,
the OEM integrator will be responsible for re-evaluating the end product (including the transmitter) and obtaining a separate FCC authorization.
Manual Information To the End User
The OEM integrator has to be aware not to provide information to the end user regarding how to install or remove this RF module
in the user’s manual
of the end product which integrates this module.
The end user manual shall include all required regulatory information/warning as show in this manual.
OEM/Host manufacturer responsibilities
OEM/Host manufacturers are ultimately responsible for the compliance of the Host and Module.
The final product must be reassessed against all the essential requirements of the FCC rule such as FCC Part 15 Subpart B
before it can be placed on the US market.
This includes reassessing the transmitter module for compliance with the Radio and EMF essential requirements of the FCC rules.
This module must not be incorporated into any other device or system without retesting for compliance as multi-radio and combined equipment.