ACS-CONTROL-SYSTEM GmbH
l Lauterbachstr. 57 l D-84307 Eggenfelden l www.acs-controlsystem.de l [email protected]
9
Electrical connection
The electrical connection of the device must be carried out according to the respective country specific
standards.
Incorrect installation or adjustment could cause applicationally conditioned risks.
For inauguration it is suggested to switch off all connected control devices to avoid unintended control
actions.
Potential equalization - earthing
The device must be grounded.
The earthing can be carried out by the metallic process connection.
The metallic parts of the device are electrically connected with the socket of the plug M12.
Connection cable
For the connection only suitable cables may be used, that fulfills the requirements e.g. regarding
temperature, chemical resistance or laying at the place of installation.
Use only shielded signal and measurement wires and install these wires separated from power leading
wires.
Connect the cable shield of a connected cable only at one side to earth, ideally at the installation place
of the device.
Supply voltage
The voltage applied to the terminal contacts may not exceed the maximum permitted supply voltage
to avoid damage of the electronic.
The maximum permitted supply voltage range is:
Version type GA
16…45V
DC
Version type WB
20…253V
AC/DC
All connections are reverse polarity protected.
A fuse is integrated internally at the power supply circuit. Due to this the installation of a fine
protection is not necessary.
The switch output is not protected by this fuse.
Summary of Contents for Fluxicont FP
Page 14: ......
