ACS AET62, Reference Manual

Page: 20 / 37

AET62 Reference Manual
Version 1.0
Page 20 of 37
idvation GmbH
Otto-Hesse-Straße 19 / T5 Phone +49 6151 4923021
D-64293 Darmstadt Fax +49 6151 3689296
info@idvation.com www.idvation.com
Data In: Blinking Duration Control
Byte 0
Byte 1 Byte 2 Byte 3
T1 Duration
Initial Blinking State
(Unit = 100ms) T2 Duration
Toggle Blinking State
(Unit = 100ms) Number of
repetition 0x00
Table 34: Bi-Color LED Blinking Duration Control Format (4 Bytes)
Data Out: SW1 SW2. Status Code returned by the reader.
Byte 0
SW1 SW2 Meaning
Success 90 Current LED
State The operation is completed successfully.
Error 63 00 The operation is failed.
Table 35: Status Code
Status Item Description
Bit 0 Current Red LED 1 = On; 0 = Off
Bit 1 Current Green LED 1 = On; 0 = Off
Bits 2 – 7 Reserved
Table 36: Current LED State (1 Byte)
Note:
The LED State operation will be performed after the LED Blinking operation is completed.
The LED will not be changed if the corresponding LED Mask is not enabled.
The LED will not be blinking if the corresponding LED Blinking Mask is not enabled. Also, the number of repetition must
be greater than zero.
T1 and T2 duration parameters are used for controlling the duty cycle of LED blinking. For example, if T1=1 and T2=1,
the duty cycle = 50%. #Duty Cycle = T1 / (T1 + T2).
7.3. Get the Firmware Version of the reader
This is used to retrieve the firmware version of the reader.
Command Class INS P1 P2 Le
Get
Response 0xFF 0x00 0x48 0x00 0x00
Table 37: Command Format (5 Bytes)
Response Data Out
Result Firmware Version
Table 38: Response Format (10 bytes)
E.g. Response =
41 45 54 36 32 30 33 30 30
(Hex) = AET620300 (ASCII)
7.4. Get the PICC Operating Parameter
This is used to retrieve the PICC Operating Parameter of the reader.
Command Class INS P1 P2 Le
Get
Response 0xFF 0x00 0x50 0x00 0x00
Table 39: Command Format (5 Bytes)
Response Data Out
Result PICC Operating Parameter
Table 40: Response Format (1 byte)