ACS A1214 Expert, Operation Manual, Page: 14 / 64

Ultrasonic flaw detector А1214 EXPERT
Operation Manual
14
ACOUSTIC
CONTROL
SYSTEMS
2
The instrument is designed to be operated under conditions specified in the section 1.1.2.
The protection glass against cracks during manufacturing and transportation is protected with a polyethylene film.
Remove the polyethylene film prior to work with the instrument so that to see brighter images rich in contrast.
2.2.1 Turning the device on/off
2.2.1.1 Turning on
To turn ON the instrument, press the key. At that the state
indicator of the instrument will light green. In a few seconds the
screen will display a start-up window with the name, firmware ver-
sion and a corporate logo of the ACS (Figure 7). In the next in 5 to
10 seconds the instrument will automatically enter the mode being
active before it was switched off, al the corresponding settings are
saved.
2.2.1.2 Turning off
To turn OFF the instrument, press the key.
ATTENTION: THE INSTRUMENT WILL AUTOMATICALLY SWITCH OFF
AFTER TIME PERIOD SET IN THE SYSTEM SETTINGS EXPIRES, IF NO
KEY IS PRESSED AND NO MEASUREMENT IS PERFORMED!
2.2.2 Selecting the transducer
The testing is performed using the flaw detector as followings:
2.2 PREPARING THE DEVICE FOR USE
2.1 OPERATING LIMITATIONS
INTENDED
USE
Figure 7