Acrosser Technology AR-B1894, User Manual

Page: 17 / 47

2.3.8 DVI Connector (DVI
Description PIN No. PIN No. Description
TDC0# 2 1 +5V
TDC0 4 3 GND
NC 6 5 NC
NC 8 7 NC
TDC1# 10 9 HPDET
TDC1 12 11 MDVIDATA
NC 14 13 MDVICLK
NC 16 15 Ground
TDC2# 18 17 TLC#
TDC2 20 19 TLC
Signal Type Description
TDC0,TDC0# O
DVI Data Channel 0 Output
: These pins provide the DVI differential
output for data channel 0 (Blue).
TDC1,TDC1# O
DVI Data Channel 1 Output
: These pins provide the DVI differential
output for data channel 1 (Green).
TDC2,TDC2# O
DVI Data Channel 2 Output
: These pins provide the DVI differential
output for data channel 2 (Red).
HPDET I
Hot Plug Detect (internal pull-down)
: This input determines whether the
DVI is connected to a DVI monitor. When terminated , the monitor is
required to apply a voltage greater than 2.4 volts. Changes on the status
of this pin will be relayed to the graphics controller via the P-OUT/TLDET*
or GPIO(1)/TLDET* pin pulling low.
TMDSDATA I/O
DVI I2C Data
: This signal is used as the I2C DOC clock for a digital
display connector (i.e. TV-Out Encoder , TMDS transmitter ). This signal
is tri-stated during a hard reset.
TMDSDCLK I/O
DVI DOC Clock
: This signal is used as the DOC clock for a digital display
connector (i.e. primary digital monitor). This signal is tri-stated during a
hard reset.
TLC,TLC# O
DVI Clock Output:
These pins provide the differential clock outputs to the
DVI interface corresponding a data on TDC(0:2) outputs.
2.3.9
GPIO Connector (GPIO1)
2.3.10
IrDA Connector (IR1)
PIN No. Description
1 +3.3V
2 General Purpose I/O bit 3
3 General Purpose I/O bit 5
4 General Purpose I/O bit 0
5 General Purpose I/O bit 7
6 General Purpose I/O bit 2
7 General Purpose I/O bit 4
8 General Purpose I/O bit 1
9 General Purpose I/O bit 6
10 Ground
PIN No. Description
1 NC
2 NC
3
+5V
4 Infrared transmitter output
5 Ground
6 Infrared receiver input