Acrosser Technology AIV-QM97V1FL Series, User Manual, Page: 11 / 76

AIV-QM97V1FL Series User Manual
11 www.acrosser.com
1.3.2. Front I/O Panel
USB3, USB4
(USB2.0)
DC Power In
Status LED COM1 COM2 COM3
DVI
HDMI
USB1, USB2
(USB3.0)
Remote
Switch
GPIO
Mic In
Line Out
LAN1 LAN2
DC Power In
9~32VDC Power input.
Status/HDD/Power LED Display
LED Light Display
G Green Status
G Green SATA Device Activity
Y Yellow Power LED
Status LED Flashing Status:
A Status LED is used to indicate the status of the system. In normal condition, the
LED will flash a number of blink to state the status. Each blink remains 200 ms ON
followed by a 200 ms OFF. Each Cycle will have a 2-second OFF in between.
LED Blinking
Numbers
Status
0 (Constant On) Power output runs normally.
1 Standby Mode (System off)
2 Hard Off Delay
3 Power On Delay
4 Shutdown Delay
5 Boot Up Delay
6 Soft Off Delay
If abnormal condition occur, the LED will flash a 1.5-second pulse followed by
numbers of 200 ms pulse to indicate the error status.
LED Blinking
Numbers
Error Status
1 Long, 1 Short
System cannot be turned on or was turned off because
battery voltage is below the Battery Low Voltage.
1 Long, 2 Short
System on/off fail. When motherboard cannot turn on or turn
off after retry.