acropaq APS26K, User Manual

Page: 15 / 36

6 | Page
6. MOTOR PROTECTION
The motor switches off automatically in the event of an overload. First of all, disconnect the power
plug from the power socket and allow the motor to cool down to room temperature. Then connect
the power plug to the power socket again and continue operation.
Note! Observe the continuous operation time stipulated in Chapter "Technical Data".
7. CLEARING PAPER JAMS
If too much paper is fed into the cutting mechanism, a paper jam occurs. The shredder switches off
automatically in the event of a paper jam.
Proceed as follows:
-
Press the Rev button to activate reverse operation and feed the paper back out.
- Remove any residual paper from the entry using the forward feed ( Auto ).
Note! If the jam is not cleared by the reverse/forward running process, disconnect the power plug
and remove the residual paper from the cutting mechanism manually.
-
Set the sliding switch to Auto .
-
Reduce the quantity of paper being shred and continue with the shredding process.
Rev setting (reverse operation)
Set the sliding switch to
Rev
so that the cutting mechanism runs in reverse and releases the paper.
Forward feed (Auto)
Set the sliding switch to
Auto
in order to ensure any residual paper is shredded and removed from
the cutting mechanism.