1
ASJ series residual current operated relay
1 Introduction
ASJ series residual current operated relay can be combined with low voltage circuit breaker or
low voltage contactor to form a residual current protection device, which is mainly used for the TT
and TN system distribution lines with AC 50Hz and rated voltage of 400V and below. It is used to
protect the electrical circuit form ground faults, prevent equipment damage caused by earth fault
current and electrical fire accidents, and can also be used to provide indirect contact protection
against personal electric shock hazard.
Products meet the requirements of GB/T 22387-2016
residual current operated relay
.
2 Types of Products
Type
Function
Installation
Appearance
ASJ10-LD1C
AC-type residual current measurement;
Alarm prompt of current crossing line;
Rated residual operating current can be measured;
Limit non-driving time can be set;
Two sets of relay output;
With local and remote “test” and “reset” functions.
Guide
(DIN
35mm)
ASJ10-LD1A
A-type residual current measurement;
Current percentage light column display;
Rated residual operating current can be measured;
Limit non-driving time can be set;
Two sets of relay output (settable)
note 1
;
With local and remote “test” and “reset” functions.
ASJ10L-LD1A
note2
A-type residual current measurement;
Rated residual operating current can be measured;
Limit non-driving time can be set;
Two sets of relay output (settable);
Transformer breakage alarm can be set;
Pre-alarm value can be set;
Return value can be set.
With on-site display, remote "test", "reset"
LCD display, 25 event records.
ASJ20-LD1C
AC-type residual current measurement;
Alarm prompt of current crossing line;
Rated residual operating current can be measured;
Limit non-driving time can be set;
Two sets of relay output;
With local and remote “test” and “reset” functions.
Panel
(48*48)
