1. Horn On/Off Switch: In the “down” position, this engages the piezo horn.
2. Combo Locking Speaker Connector Jack: Connects your amplifier head to the speaker
cabinet via locking connector or 1/4” speaker connector.
3. Parallel 1/4” Speaker Jacks:
a. These jacks can output to a second or third speaker cabinet in parallel mode* if the
Combo Locking Speaker Connector jack is used for your signal input.
b. If you’re not using the Combo Locking Speaker Connector jack, either of these jacks
can be used to input your amplified signal while the other jack can then be used as an
output to connect to a second speaker.
* Please note: when running in parallel mode the speakers combined ohm load should
not go below your amplifier head’s minimum ohm rating. For example, please refer to the
table below.
We do not recommend combining speaker cabinets with differing ohm ratings.
1
2
3
B115C and B410C
MODEL
B410C
Power Handling (RMS)
400 Watts RMS
Speakers
4 X 10” custom ferrite drivers
Hi-Frequency Driver
Piezo horn, switchable
Frequency Response
40Hz -16kHz
Max SPL
130dB (half-space measurement)
Inputs
Dual 1/4” (parallel), Combo Locking Speaker Jack
Impedance
8 Ohms
Handles
Retractable spring-loaded (side)
Caster Sockets
Yes
Port
Front Facing Shelf
Dimensions (LxWxH)
24” x 16.1” x 27”/61.1cm x 41cm x 68.5cm
Weight
64 lbs/29 kg
No. of Cabs & Ohm Rating
Final Load presented to Amplifier
2 x 16 ohm cabs
8 ohms
2 x 8 ohm cabs
4 ohms
2 x 4 ohm cabs
2 ohms
MODEL
B115C
Power Handling (RMS)
350 Watts RMS
Speakers
1 X 15” custom ferrite drivers
Hi-Frequency Driver
Piezo horn, switchable
Frequency Response
35Hz -15kHz
Max SPL
130dB (half-space measurement)
Inputs
Dual 1/4” (parallel), Combo Locking Speaker Jack
Impedance
8 Ohms
Handles
Retractable spring-loaded (side)
Caster Sockets
Yes
Port
Rear Facing
Dimensions (LxWxH)
24” x 16.1” x 24.3”/61.1cm x 41cm x 59.6cm
Weight
55.4 lbs/25 kg
