AV100
3
FCC Information
Note:
This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant
to Part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful in-
terference in a residential installation. This equipment generates, uses and can radiate radio frequency
energy and, if not installed and used in accordance with the instructions, may cause harmful interference
to radio communications. However, there is no guarantee that interference will not occur in a particular
installation. If this equipment does cause harmful interference to radio or television reception, which
can be determined by turning the equipment off or on, the user is encouraged to try to correct the interfer-
ence by one or more of the following measures:
— Reorient or relocate the receiving antenna.
— Increase the separation between the equipment and receiver.
— Connect the equipment into an outlet on a circuit different from that to which
the receiver is connected.
— Consult the dealer or an experienced Radio/TV technician for help.
This device complies with Part 15 of the FCC Rules. Operation is subject to the following two conditions: (1) This
device may not cause harmful interference, and (2) this device must accept any interference received, including
interference that may cause undesired operation.
The user is cautioned that changes or modifications not expressly approved by XM
®
Satellite Radio, Inc. can void
the user’s authority to operate this device.
By adhering to these warnings and safety considerations, accidents and/or personal injury can be avoided.
Safety Precautions
z
Do not expose the device and the remote control to water or moisture.
z
Only operate the device in the specified temperature range of 0°C to 40°C.
z
Make sure there is sufficient ventilation for the device. There must be a minimum gap of 10 cm between
objects to the side, to the rear and above the device.
z
In the event of contact with moisture or liquids remove the mains adapter immediately.
z
Only clean the device using a dry cloth. Do not use any cleaning agents or chemical solvents when
cleaning, as these could damage the surface of the device.
z
Never open the device.
z
The device should not continue to be operated if there is visible damage to the mains cable. A damaged
cable should not be repaired, but must be replaced.
z
Always refer to a qualified specialist for any maintenance or repair work.
