STEP 3
STEP 4
STEP 5
Page. 3
LIMITS ARE NOW SET
FOR AUTOMATE Q S45 & S60 MOTOR ONLY
S E T F A V O U R I T E P O S I T I O N
a. Set desired lower limit posi on (using UP and DOWN bu ons).
b. If needed, put motor in Stepping Mode by pressing
P2 while motor is moving.
c. Once blind is at desired posi on, press STOP for 5 seconds un l
motor con
fi
rms posi on.
To con
fi
rm limit, motor will jolt down and up.
It is possible to programme mul
Ɵ
ple motors on each channel.
To program another motor on the same channel, turn OFF motor 1, turn ON motor 2 and repeat steps from 1 to 5.
a. Press P2 bu on (x1).
b. Press UP bu on (x1).
c. Press P2 bu on (x1).
To con
fi
rm se
ƫ
ng mode, motor will beep 3
Ɵ
mes and jolt up and down.
P2 (x1)
UP (x1)
P2 (x1)
SET UPPER LIMIT FIRST
*To program an A50/C Motor go to Step 5
a. Set desired upper limit posi on
fi
rst (using UP and DOWN bu ons).
b. When a more accurate se ng is required put motor in
Stepping Mode by pressing P2 while motor is moving up/down.
c. Once blind is at desired posi on, press STOP for 5 seconds un l
motor con
fi
rms posi on.
To con
fi
rm limit, motor will jolt down and up.
UP (x1)
Hold STOP for 5 sec
SET LOWER LIMIT
DOWN (x1)
Hold STOP for 5 sec
TO SEND BLIND TO FAVOURED POSITION,
PRESS THE STOP BUT TON FOR 5 SECONDS.
Hold STOP for 5 sec
UP/DOWN
PUT MOTOR IN LIMIT SETTING MODE
• Use UP and DOWN to
fi
nd your favourite posi on.
• Press STOP for 5 seconds un l motor con
fi
rms posi on.
To con
fi
rm limit, motor will jolt.
UP/DOWN
DOWN (x1)
UP (x1)
UP (x1)
old STOP for 5 se
Hold STOP for 5 se
Hold STOP for 5 se
P2 (x1)
P2 (x1)
