XP-1200F
15-
from 1 to 512 channels so that the units can receive DMX signal.
Press the
MENU
button up to when the
is shown on the display. Pressing
ENTER
button and the display will blink. Use
DOWN
and
UP
button to change the DMX512
address. Once the address has been selected, press and keep
ENTER
button pressed up
to when the display stops blinking or storing automatically 8 seconds later. To go back to
the functions without any change press the
MENU
button again.
Please refer to the following diagram to address your DMX512 channel for the first 4 units.
6 Channels
：
7.4 DMX512 Configuration
XP-1200F
4-
y
Avoid any inflammable liquids, water or metal objects entering the unit. Once it happen,
cut off the mains power immediately.
y
Do not operate in dirty and dusty environment, also cleaning fixtures regularly.
y
Do not allow children to operate the fixture.
y
Do not touch any wire during operation as there might be a hazard of electric shock.
y
Avoid power wires together arounding other cables.
y
The minimum distance between light output and the illuminate surface must be more
than 2.5 meters.
y
Disconnect mains power before fuse/lamp replacement or servicing.
y
Replace fuse/lamp only with the same type.
y
In the event of serious operating problem, stop using the unit immediately.
y
Never turn on and off the unit time after time.
y
The housing, the lenses, or the ultraviolet filter must be replaced if they are visibly
damaged.
y
Do not open the unit as there are no user serviceable parts inside.
y
Never try to repair the unit by yourself. Repairs carried out by unskilled people can lead
to damage or malfunction. Please contact the nearest authorized technical assistance
center.
y
Disconnect the mains power if the fixture is not used for a long time.
y
Do use original packing materials once transport it again.
Caution
y
To prevent or reduce the risk of electrical shock or fire, do not expose the unit to rain or
moisture.
y
Hot lamp explosion hazard. Do not open the unit within 15 minutes after switching off.
y
Do replace the bulb once it is damaged, distortion or over lifespan.
y
Do not look directly at the light while the bulb is on.
y
Never touch bulb with bare fingers, as it is very hot after using.
y
Do not start on the unit without bulb enclosure or when housing is damaged.
Product Items
y
User
manual
y
2 x Omega clamps