Rear view:
Power Switch Turn On/Off the power
DC Input DC 9V, 300mA min
DMX Output Set DMX value to the fixture
2. Address Setting
A. Each fixture needs to have an address set to receive the data sent by the controller.
B. No need to turn the fixture off when you change the DMX address, as new DMX address setting will
be effected at once.
Please follow the instructions below to set these address:
y
Connecting all LED lightings to the LED-RC64 and power them on.
y
Hold the “black out” button for about 5 seconds until the LED blinking.
y
All LED lightings will light in white, and show their addresses on the display.
y
Press “red” button to set address for matrix 1, press “orange” button to set address for matrix 2.
y
Press white button to change the direction.
y
Press the “black out” button for about 5 seconds to quit address setting.
3. How to connect the unit
Please refer to the following diagram to connect the fixtures:
