4.3 Change The Lamp
Do not use this lamp more than 1000 hours, using the lamp any longer than its set life could
seriously damage your unit. Periodically checking the lamp running time, when the lamp reaches
the 1000 hour mark, or close to it, we strongly suggest you switch the lamp out. Clear the RESET
TIME after you have replaced the lamp.
To replace the lamp:
1.
Ensure that the fixture is detached from power and has cooled down completely. It is a good
idea to allow the fixture to run for 10 minutes after the lamp has been turned off, so that the
cooling fans have time to works.
2.
Loosen the screws on the head of the fixture and open the fixture head covers.
3.
Loosen the screw that holds the lamp in place. Unplug the leads of the lamp and lift the lamp
out of its recess, disconnect the lamp and connect a new lamp that must be the same type with
the old one. And then place the new lamp into the lamp recess.
Finally reinstall the head cover, fastening it securely before reapplying power.
8C
Summary of Contents for SABER HYBRID PRO
Page 1: ......
Page 11: ...10C ...
