Acme Manufacturing Company
4240 N. Atlantic Blvd.
Auburn Hills, Michigan 48326 U.S.A.
Phone (248)393-7300
Fax (248) 393-4060
Acme Manufacturing Company
www.acmemfg.com
OW-Head leaks
o
Leaks from nozzle
o
Compound emerges from the bleed bores on OW-Head
Replace OW-Head
Compound leaks from bleed holes in main body (28)
o
Replacement of plunger (36) and cup seal (9) are required
(replacement of compression spring (37) should also be done at this
time)
When dismounting and cleaning the spray gun, it is necessary to use the
drawing with parts list.
Safety
The following safety recommendations should be followed when doing any work
on the spray gun:
Never point the spray gun at other personnel
Before any repair or maintenance work may be carried out, spray gun must
be disconnected from compressed air and pressure must be released
Always wear protective glasses
Close compound supply stopcock
Before start-up and after each repair or maintenance work, all nuts, bolts and
connections should be reviewed to confirm that all are tight and properly
installed
Pay attention to the warnings and advices of the compound, buff and
equipment manufacturer
Do not use aggressive cleaners or boiling water to clean gun or parts.
Nozzles can be cleaned with compressed air or warm water and compressed
air. Exterior of gun can be cleaned with a damp cloth or fiber brush.
Changes in the interest of improvements and technical progress are reserved.
