Fixture Temp.
Press the
MENU
button up to when the
Fixture Temp.
is blinking on the display. Pressing
ENTER
button and the display will show the temperature of the unit. To go back to the
functions press the
MENU
button again. Hold and press the
MENU
button about one second
or wait for one minute to exit the menu mode.
Fixture Time
Press the
MENU
button up to when the
Fixture Time
is blinking on the display. Pressing
ENTER
button and the display will show the number of working hours of the unit. To go back
to the functions press the
MENU
button again. Hold and press the
MENU
button about one
second or wait for one minute to exit the menu mode.
Firmware Version
Press the
MENU
button up to when the
Firmware version
is blinking on the display.
Pressing
ENTER
button and the display will show the version of software of the unit. To go
back to the functions press the
MENU
button again. Hold and press the
MENU
button about
one second or wait for one minute to exit the menu mode.
PRO Defaults
Press the
MENU
button to show
PRO Defaults
on the display. Press the
ENTER
button and
the display will blink. Use the
DOWN
and
UP
button to select the
Yes
(run built-in program
to set the fixture to PRO Defaults settings) or
No
. Press the
ENTER
button to setup, to go
back to the functions without any change press the
MENU
button again. Hold and press the
MENU
button about one second or wait for one minute to exit the menu mode.
Reset
Press the
MENU
button up to when the
Reset
is blinking on the display. Pressing
ENTER
button and all channels of the unit will return to their standard position.
5. How to Control the Unit
You can operate the unit in two ways:
1. By master/slave built-in preprogram function
2. By DMX controller
No need to turn the unit off when you change the DMX address, as new DMX address
setting will be affected at once. Every time you turn the unit on, it will show “LP-TS100” on
8A
