2-
1. Safety Instruction
WARNING
♦
Please keep this User Manual for future consultation. If you sell the unit to another user,
be sure that they also receive this instruction booklet.
♦
Unpack and check carefully there is no transportation damage before using the unit.
♦
Before operating, ensure that the voltage and frequency of power supply match the power
requirements of the unit.
♦
It’s important to ground the yellow/green conductor to earth in order to avoid electric
shock.
♦
The unit is for indoor use only and use only in a dry location.
♦
The unit must be installed in a location with adequate ventilation, at least 50cm from
adjacent surfaces. Be sure that no ventilation slots are blocked.
♦
Disconnect mains power before fuse replacement or servicing.
♦
Replace fuse only with the same type.
♦
Make sure there are not flammable materials close to the unit while operating as it is fire
hazard.
♦
Use safety cable when fixes this unit.
♦
Maximum ambient temperature is TA: 40
℃
and don’t operate it where the temperature is
higher than this.
♦
Unit surface temperature may reach up to 60
℃
. Don’t touch the housing bare-hand during
its operation. Turn the power off and wait for 15 minutes for cool down before replacing
bulb or serving.
♦
In the event of serious operating problem, stop using the unit immediately. Never try to
repair the unit by yourself. Repair carried out by unskilled people can lead to damage or
malfunction. Please contact the nearest authorized technical assistance center and
always use the same type spare parts.
♦
Don’t connect the device to any dimmer pack or power pack.
♦
Do not touch any wire during operation as high voltage might be causing electric shock.
Please read the instruction carefully which including important
information about the installation, operation and maintenance.
3-
2. Technical Specification
•
Voltage: AC 100V-240V 50-60Hz
•
2 Channels
Channel 1 = Dimmer/Strobe
Channel 2 = Rotation
•
It can be operated by DMX512 control or can be used as an individual unit without
controller.
•
It can be linked together as many as required in master/slave mode, and perform the great
built-in programmed lighting shows triggered by music.
•
Please use a 3 pin XLR cable/plug when connecting them together.
•
Fan cooled.
•
Dimension: 194 x 202 x 141 mm
•
Weight: 1kg
3. Installation
You can install the unit on the truss or ceiling, Use clamps to fix the unit to truss. Always
ensure that the unit is firmly fixed to avoid vibration and slipping while operating. Always
ensure that the structure to which you are attaching the unit is secure and is able to support
a weight of 10 kg
for each unit.