Debugging
Error Reason
Resolution
Model doesn´t react.
Accumulator is not charged
Load accumulator.
Remote control is not switched on
Switch on remote control.
Accumulator plug is not connected the right.
Open the shutter of models accumulator and
check the connection.
Empty batteries inside remote control.
Change batteries – charge accumulators.
Check the connection of the charging lead.
The model can´t be controled resp. just hardly
controlled.
Batteries / accumulator to weak.
Load accumulators – if necessary change
batteries
Remote control with a wrong frequency.
Just use supplied remote control!
The Electronics or engine of the model is damaged.
Installation of new electronics – on
www.Hi-Skyper.com
you will find suppliers.
Contact breaks down after 5 – 15 meters.
Models antenna abrupt – (let it) solder
Contact breaks down after 30 – 50 meters
Receiver or transmitter board damaged –
service
Servo reacts slowly resp. delays control commands.
Servo damaged
Change defective servo
Model doesn´t keep the track. (ice, asphalt)
On a hard, slick ground the model just changes the
direction by the propellers boost.
For the usage on iced surfaces the Hi-Skyper
can be modified by little lightweight steel
edges.
Model can be controled hardly.
Foreign objects disrupt the free run of the propellers.
Clean the model
Fuselag seriously damaged.
Repair damages like crannies or breakings by
Blue Glue or change damaged parts.
The wind speed is to high, it´s squally.
Wait for better wheather.
The model tilts to the left or right during flying,
without touching the controlstick.
The Hi-Skyper is pretty wobbly caused by its
construction type.
Constant steering into the opposite direction
is necessary.
The model doesn´t start from the water.
Accumulator not charged completely.
Charge accumulator.
Accumulator exhausted.
Insert new accumulator
The fuselag is damaged and the the EPP soaks up
water – the model becomes to heavy.
Let the model dry off and caulk the damaged
parts by Blue Glue. If necessary replace
fuselag or vats.
The model doesn´t slide straight.
The plastic sliders are damaged.
Stick new plastic sliders on the model.
Trimming is not alright.
Trim rudders
The surface falls off to one side.
Choose another surface for starting
Sidewind affects the sliding.
Always start against the wind.
Schematic
4
1 3
2
Further hints are available on the Hi-Skyper homepage: www.Hi-Skyper.com
