FlyCamOne
2
www.FlyCamOne.com
Content
Exclusive
SE
version
Camera
Velcro-pad
Eyeletband
Baseplate
w.Servo
(inst.
Baseplate)
Baseplate
Servoarm
+
screw
USB-Cable
Trigger-Controlcabel
ATTENTION! The application in cars for observation and accident reconstruction is not covered by the guarantee. Through a collision at a high
speed, the record can be deleted.
ATTENTION!
The privacy of others is protected by law and should be taboo. The recording of third party can be a illegal act. You are responsible for your
acting.
Start
Remove the film protecting the lens first. Put a suitable SD-Card (FCO
2
Rapid Rush 4.0 2GB) into the SD-Card slot of the FlyCamOne
2
(FCO
2
).
Slide the switch [1] to position “ON” and press the shutter button [2]; on the display appears “
” for ready.
Choose your mode by pressing the mode button [3] Start and stop each time by pressing the shutter button [2].
Download the data
Choose „
“ and connect the FCO² with the supplied USB-cable and your PC.
The FCO² will be displayed as a single drive. Attend that network drives can interfere the FCO² drive.
Cut the network drives. Of course you can connect the SD-card directly to your pc card reader.
Charge the FCO
2
The charging starts on its own by connecting the FCO² with the PC.
It will take approximately 3 hours to charge the FCO².
The battery status is indicated in percent below modes as follows:
,
,
.
Recharge the cam when “
“ is displayed.
