6.
2
Address Setting
If you use a universal DMX controller to control the units, you have to set DMX address from 1 to
512 so that the units can receive DMX signal.
Press the MENU button to enter menu mode, select DMX Settings, press the ENTER button to
confirm, use the UP/DOWN button to select DMX Address, press the ENTER button to confirm, the
present address will blink on the display, use the UP/DOWN button to adjust the address from 001
to 512, press the ENTER button to store. Press the MENU button back to the last menu or let the
unit idle one minute to exit menu mode.
Please refer to the following diagram to address your DMX512 channel for the first 4 units.
Channel mode
Unit 1
Address
Unit 2
Address
Unit 3
Address
Unit 4
Address
27 channels
1
28
55
82
52 channels
1
53
105
157
6.
3
DMX512 Configuration
Please refer to the following channel Diagram to control the lights note: 1. If you
disconnect the DMX signal, the lamp will remain in the state it was before the signal
was disconnected, unless you reset it. 2. In the "function" channel, hold the channel
value for about 25 seconds and the lamp will run the corresponding function. This
lamp IPLAY mode has 2 kinds of channel modes 27CH and 52CH (channel mode can
be selected from system setting → channel number setting) , SD mode is not affected
by channel number setting, SD PLAY only has 1 channel mode, the mode and
explanation are as follows:
13
C
