4B
2. Technical Specification
y
It can be operated by DMX512 control or can be used as an individual unit without
controller.
y
It can be linked together as many as required in master/slave mode, and perform the
great built-in programmed lighting shows triggered by music.
y
Please use a 3 pin XLR cable/plug when connecting them together.
y
Fan
cooled.
y
4Channels:
Channel 1 = Red
Channel 2 = Green
Channel 3 = Blue
Channel 4 = Dimmer/Strobe
y
Voltage:
AC
100V-240V
50/60Hz
y
Power: 7 W
y
Light Source: 1
×
3W RGB LED
y
Dimension:
222x300x124mm
y
Weight: 1.3 kg
3. Installation
You can install the unit on the truss or ceiling, Use clamps to fix the unit to truss. Always
ensure that the unit is firmly fixed to avoid vibration and slipping while operating. Always
ensure that the structure to which you are attaching the unit is secure and is able to support
a weight of 10 kg
for each unit.
4. How To Control The Unit
Three ways to operation:
A. Master/Slave operation
B. Easy controller CA-8
C. Universal DMX controller
5B
A. Master/Slave operation
The unit can be linked together in daisy chain as many as you need in master/slave mode to
perform the great built-in pre-programmed lighting shows triggered by music.
In Master/Slave mode, refer to the DMX settings below:
Master unit: DIP switch #10 = ON
Slave units: All DIP switches OFF
2-light show:
Turn on the DIP switch #10 for the first unit and DIP switches #1 and #3 for the other, then
you can enjoy different lighting shows of the two units.
B. Easy Controller (by CA-8)
The easy remote control is used only in master/slave mode. By connecting to the 1/4”
microphone jack of the first unit (its DMX input plug is not used), you will find that the remote
control all the first unit will control all the other units for Stand by, Function and Mode. Built-in
lighting shows triggered by Easy Controller:
Stand by
Blackout the unit
Function
1. Synchronous Strobe
2. Four light Strobe
3. Sound Strobe
Chase
Mode
Strobe (LED OFF)
Latch (LED ON)
C. Universal DMX controller
When using a universal DMX controller to control the chain of units, you have to set DMX
address by Dip switches from 1 to 9 to make sure all the units will receive its DMX signal.
Please refer to the following diagram to know how to address your DMX 512 system in the
binary code.
DMX 512 Address Chart:
Dip-switches
# 1
# 2
# 3
# 4
# 5
# 6
# 7
# 8
# 9
#10
Value 1
2
4
8
16
32
64
128
256
4-light
show
•
Examples:
Channel 1
：
dip / on: #1 (=1)
