17B
6. Troubleshooting
If the fixture does not work, no light, please check the connection of power cable
and signal line, also measure the mains voltage on the main connector.
Problem
Possible Cause
Action
The unit does not work, no
light.
Incorrect power cable connection.
Check the connection of power.
Incorrect mains voltage.
Measure the mains voltage on the
main connector.
The unit does not respond
properly
to
the
DMX
control.
Incorrect DMX cable connection.
Check DMX connectors and
cables to see if link properly.
Repair or replace damaged wires.
Incorrect address assignment to
the units.
Check the addresses of the units
and the protocol settings.
Unfinished data connection.
Insert a terminal plug in the
output jack of the last unit of the
connection.
It has been set up an operating
mode different from the DMX
mode used.
Check the operating mode set up.
Try
to
use
another
DMX
controller.
6B
3. DMX IN:
Water proof 3-pin XLR connectors for DMX 512 operation
4. POWER IN:
Water proof connectors for power input
5. POWER OUT:
Water proof connectors for power output
6. DMX OUT:
Water proof connectors for DMX 512 operation with 3-pin XLR plug
3.2 Main Functions
To select any functions, press the
MENU
button until the required one is shown on
the display. Select the function by the
ENTER
button and the display will blink. Use
the
DOWN
and
UP
button to change the mode. Once the required mode has been
selected, press the
ENTER
button to setup or it will automatically return to the main
functions without any change after idling one minute. Back to the functions without
any change press the
MENU
button.
The main functions are shown below: