-
5
-
FINAL INSTALLATION
1.
Install the device
Place the device in an appropriate place.
2.
Check the orientation of the antennas
Insure that their position
allows proper communication with the peer Wi-
Fi devices.
Specifically, insure that there are
no obstacles
between the device and
its peers (“line of sight” concept).
QUICKLY EVALUATE AP & BRIDGE MODES
Quickly evaluate the ACKSYS device in AP role
You need a second computer (PC2) with a working Wireless connection.
Set up the PC2 Wireless network interface according to the default
parameters of the ACKSYS AP device (802.11gn, SSID
“acksys”, no
security).
Quickly evaluate the ACKSYS device in client role
You need two ACKSYS devices, and a second computer (PC2) with a wired
LAN connection.
Set up the IP addresses according to the picture above and set the device
connected to PC2 to Client (infrastructure) role.
From each PC, start a command prompt and run the ping command to verify
the link.
From PC1: type
ping 192.168.1.2,
verify the answer returned by PC2
«
Answer from 192.168.1.2
… »
From PC 2: type
ping 192.168.1.1,
verify the answer returned by PC1
«
Answer from 192.168.1.1
… »
Notice:
The State LED is flashing until the bridge connects to the
AP
.
