Self Clean Mode
Press C
LEAN
to activate or deactivate the self−cleaning function. Under
this function, the air conditioner automatically cleans and dries the
evaporator. The cleaning cycle takes 16 minutes, after which the unit
turns off automatically. Press
CLEAN
on the middle of the cycle to cancel
the operation and turn off the unit. This function can be activated only in
the
COOL
or
DRY
mode.
Follow Me Mode
Press
FOLLOW ME
to activate or deactivate this function. Under this
setting, the temperature that appears in the remote control is the
actual temperature at its location. The remote control sends this
signal to the air conditioner every 3 minutes. This function is not
available for
DRY
and
FAN
modes.
Freeze Protection Mode
Press
FP
for approximately 2 seconds to activate or deactivate the
FREEZE PROTECTION
mode (heating set back). The indoor unit
displays “
FP
”.
NOTE: This function is only available in the heating mode.
Under this function, the unit operates at a high fan speed and the
coil temperature automatically sets to 46 F (8 C). This mode can
also be deactivated by pressing the “
On/Off
”,
“Sleep”
,
“Mode”
,
“Fan”
, or either
“TEMP”
buttons.
Silence Mode
Press
SLC
to activate or deactivate the
SILENCE m
ode. Under this
function, the compressor operates at a low frequency and the indoor
unit produces a faint breeze, which reduces the noise to the lowest
level. Due to the low frequency operation of the compressor, it may
result in insufficient cooling and heating capacity.
LED Light
Press
LED
to turn the display light on and off.
Resetting the Remote Control
If the batteries in the remote control are removed, the current settings
will be cancelled and the control returns to the initial settings and will be
in standby mode. Push the
ON/OFF
button to activate it.
Time Delay
If the
ON/OFF
button is pressed too soon after a stop, the
compressor will not start for 3 to 4 minutes due to the inherent
protection against frequent compressor cycling. The unit only
emits an audible beep when the signals are received correctly.
Heating Features
If the unit is in the heating mode, there is a delay when the fan
starts. The fan starts only after the coil is warmed up to prevent
cold blow.
Auto Defrost Operation
In heating mode, if the outdoor coil is frosted, the indoor fan and
outdoor fan turns off while the system removes the frost on the
outdoor coil. The system automatically reverts to normal operation
when frost is removed from the outdoor unit.
Auto Start
If the power fails while the unit is operating, the unit stores the
operating condition, and it will start operation automatically under
those conditions when the power is restored.
Page
1
4
