Automation Components, Inc.
2305 Pleasant View Road | Middleton, WI 53562
Phone:
1-888-967-5224 |
Website:
workaci.com
Page 2
Version: 12.0
I0000791
WIRING INSTRUCTIONS
Shielded cable with 14 to 24AWG conductors is
recommended. Use the Wiring Connections table
below to determine the proper wiring for your
application. Insert the wire into the depluggable
terminal block sockets and tighten the screws. In
some circumstances, it may be easier to remove
the terminal blocks while connecting the wires.
Refer to
TABLE 1
(below).
All wiring must comply with local and National
Electric Codes.
Note:
When using a shielded cable, be sure to
connect only (1) end of the shield to ground
at the controller. Connecting both ends of the
shield to ground may cause a ground loop. When
removing the shield from the sensor end, make
sure to properly trim the shield to prevent any
chance of shorting.
OUTPUT SIGNAL
SUPPLY VOLTAGE
WIRE CONNECTIONS
0-5/10VDC
AC/DC
VIN
GND
OUT
4-20mA
AC
VIN
GND
OUT
4-20mA
DC
VIN
-----
OUT
