FIGURE 5:
INDIVIDUAL INPUT
JUMPER SHUNT SETTINGS
FIGURE 4:
TERMINAL BLOCK INSTALLATION
Automation Components, Inc.
2305 Pleasant View Road | Middleton, WI 53562
Phone:
1-888-967-5224 |
Website:
workaci.com
Page 3
Version: 1.0
I0000953
Jxx
Analog Digital
10V
20V
20mA
5V
Jxx
Binary/Digital Mode
Note:
Jumpers
are factory set,
and should not
be adjusted.
Wiring Connections
Connect Input Signal Common (-) to terminals
labeled (-) labeled AI1 thru AI6.
Connect Input Signal (+) to respective terminal (+)
labeled AI1 thru AI6.
Connect controlled device to SIG OUT (+) and (-).
Connect 24 VAC to terminals marked 24 VAC (+) and
(-). See
Figure 2
(p.2).
Operation
The 6N1-ISO-STG can:
Fan Mode #1
Check inputs sequentially high(#6) to low(#1), to
set output percentage. The output percentage is
based on highest input pressed, and ignores
others. This is based on the Input # priority.
Example #1: 4 Inputs used, 0-10VDC output
Activate Input #3. Output = 7.5VDC (3/4 = 75%)
Example #2: 6 Inputs used, 0-10VDC output
Activate Input #4. Output = 6.6VDC (4/6 =
66.6%)
Fan Mode #2
Check total number of inputs, to set output
percentage. The output percentage based on
total number of inputs active.
Example #1: 4 Inputs used, 0-10VDC output
Activate Input #1 and #3. Output = 5VDC
(50%)
Example #2: 4 Inputs used, 0-10VDC output
Activate Input #3. Output = 2.5VDC (25%)
Example #3: 6 Inputs used, 0-10VDC output
Activate Input #1, #4, #5, #6. Output = 6.6VDC
(4/6 = 66.6%)
CALIBRATION, JUMPER & DIP
SWITCH SETTINGS
The 6N1-ISO-STG output is factory calibrated in
all four DIP switch selectable output ranges. Do
not adjust the potentiometers on the
6N1-ISO-STG as this may void any warranty.
