32
English
Replacing the Lamp
Use a screwdriver to remove the screw(s) from the cover, and then pull out the
lamp. Make sure the projector has been cooling down for at least 45 minutes
before changing the lamp.
Warning: The lamp compartment is hot! Allow it to cool down
before changing the lamp.
To Change the Lamp
Turn off the projector by pressing the Power button.
Allow the projector at least 45 minutes to cool down.
Disconnect the power cord.
1
Remove the screw (a) and slide the
lamp cover (b) for removal.
2
Disconnect the lamp connector (c).
3
Remove the screw (d) that secure
the lamp module.
Pull out the lamp module (e) by
the handle (f).
To replace the lamp module, use a new
lamp and reverse the above steps.
Warning: To reduce the risk of personal injury, do not drop the
lamp module or touch the lamp bulb. The bulb may shatter and
cause injury if it is dropped.
(a)
(b)
(f)
(e)
(c)
(d)
