12
2.2 Assembly Procedures:
S1 Prepare a main board, a power board and some essential cables. Connect every cable as the below picture.
S2. Use a Philips-head screwdriver to tighten the screws till the power board and main board with shield are firmly
attached. Tape the Mylar. And use a Hex-head screwdriver to tighten the screws for locking the connectors.
Summary of Contents for Nitro VG240Y Series
