1-16
User’s Guide
1.7.5
Reconfiguring the System
Reconfigure the system after installing or removing SIMMs.
Follow these steps to reconfigure the system:
1.
Reboot the system. A memory error message appears,
indicating that the total memory does not match the value stored
in CMOS.
2.
Press
+
+
during the power-on self-test (POST)
routine to run Setup. During POST, a message indicating a
wrong memory configuration appears.
3.
Press
twice to exit Setup and reboot the system. The
system boots with the new memory configuration.
If you operate the system with WindowsNT,
NetWare, or UnixWare, make sure to run
ECU every time you install or remove an
EISA or a non-PnP ISA card. See Chapter 3
for information on ECU.
