Acer e-mill 3VSII, Operation Manual

Page: 92 / 203

- 9 1 -
6. OPERATION
Note: Safety operation rules review
1. SECURE WORK. Use chuck to hold work piece when it is practical. It is
safer than using your hand and this way it frees operator’s hands to operate the
lathe.
2. DO NOT OVERREACH. Keep proper footing and balance at all times.
3. MAINTAIN CUTTING TOOLS WITH CARE. Keep tools sharp and clean for
the best and safest performance. Follow instructions for lubricating and
changing accessories.
4. DISCONNECT POWER before servicing, when changing accessories such as
cutting tools.
5. REDUCE THE RISK OF UNINTENTIONAL STARTING. Make sure
EMERGENCY switch is at off -position before connecting power.
6. USE RECOMMENDED ACCESSORIES. Consult the owner’s ma nual for
recommended accessories. The usage of improper accessories may cause risk or
injury to the operators.
7. NEVER STAND ON TOOLS. Serious injury could occur, if the operator is
tripped by the tools, or if the cutting tool is unintentionally contact ed.
8. CHECK FOR DAMAGE PARTS. Before further using a tool, a guard or other
parts that appears damaged, operator should carefully checked the item to
determine that it will operate properly and perform its intended function. Please
check for alignment a nd binding of moving parts, breakage of the parts,
mounting, and any other conditions that may affect its operation. A guard or
other part that is damaged should be properly repaired or replaced.
9. NEVER LEAVE LATHE RUNNING UNATTENDED, PLEASE TURN ITS
POWER OFF. Don’t leave the lathe until it comes to a complete stop.
10. ALWAYS USE SAFETY GLASSES. Common eyeglasses only have impact
resistant lenses, they are NOT safety glasses.
11. KEEP GUARDS IN PLACE and in working order.
12. REMOVE ADJUSTING KEYS A ND WRENCHES. Form a habit of checking
to see that keys and adjusting wrenches are removed from lathe before turning it
on.
13. KEEP WORK ARE A CLEAN. Cluttered areas will invite accidents.
14. DON’T USE TOOLS IN DANGEROUS ENVIRONMENT. Don’t use power
tools in damp or wet location, or expose them to rain. Keep working area well
lighted.
15. KEEP CHILDREN AWAY. All visitors should be kept at a safe distance
from work area.
16. MAKE WORKSHOP CHILD PROOF with padlocks, master switches, or by
removing starter keys.
17. DO NOT FORCELY USING CUTTING TOOLS. Don’t force a tool or
attachment to do a job for which it was not designed for.
18. USE THE RIGHT CUTTING TOOL. It will do the job better and safer at the
rate for which it was designed for.
19. WEAR PROPER APPAREL. No loose clothing, gloves, neckties, rings,
bracelets, or other jewelry to have chance to get caught in moving parts of the
lathe. Non -slip footwear is recommended, and wears protective hair cover to
contain long hair.