1-14
Disassembly Procedures
LCD Module Removal
0
Prerequisite:
1. Disconnect the WLAN antennas (A) and remove the antennas from the cable guides
as shown in
.
2. Disconnect the eDP cable (B) from the mainboard connector (C) (
3. Disconnect the G-sensor control cable (D) from the mainboard (
).
Figure 1-15. WLAN Antenna & eDP Cable Location
4. Place the system on a flat surface and open the LCD module (D) to a 120 degree
angle as shown in
.
5. Remove four (4) screws (E) securing the LCD module (D) in place (
Figure 1-16. LCD Module Screw Location
A
B
C
D
D
E
E