Acer ATL 1840E, Operation Manual

Page: 16 / 76

Page 1-11
1.4.4 Preparations
WARNING
1) Tooling should conform to the machine specifications, dimensions types.
2) Seriously worm-out tools can cause injuries. Replace all such tools with new
ones beforehand
3) The work area should be adequately lighted to facilitate safety checks.
4) Tools and other items around the machine or equipment should be stored to
ensure good footing and clear aisles,
5) Tools or any items must not be place on the headstock, turret, cover and
similar places.
6) If the center holes of heavy cylindrical work piece are too small, the work
pieces can jump out when loaded. Be careful about center holes and angles.
CAUTION
1) Tool lengths should be within specified tolerances to prevent interference.
2) After installing a tool, make a trial run.
1.4.5 Operation
WARNING
1) Do not work with long hair that can be caught by the machine. Tie it up at
the back, out of the way.
2) Do not operate switches with gloves on. This could cause malfunctions, etc.
3) Whenever a heavy work piece must be moved, two or more persons should
always work together if there is any risk involved.
4) Only trained, qualified workers should operate forklift trucks, cranes or
similar care should be taken to prevent collisions and damage to
surroundings.
5) Whenever operating a forklift truck, crane or similar equipment, special
care should be taken to prevent collisions and damage to surroundings.
6) Wire ropes or slings should be strong enough to handle the loads to be lifted
and should conform to the mandatory provision.
7) Grip work pieces securely.
8) Stop the machine before adjusting the coolant nozzle at the tip.
9) Never touch a turning work piece or spindle with bare hands or in any other
way.